SKB 3I-13096A74 iSeries 1309 Waterproof Case for Sony A7R IV Camera

• Holds a Camera Body with Lens Attached
• Also Holds 2 More Lenses & Accessories
• IP67-Rated Dust and Waterproof
• Polypropylene Copolymer Resin Material
• UV/Solvent/Corrosion/Fungus Resistant
• Dual Trigger Release Latch System
• Custom-Cut Foam Insert
• Pressure Relief Valve
• Molded-In Hinge and Padlock Holes

• SKB iSeries 1309 Waterproof Case for Sony A7R IV Camera
• Custom-Cut Foam Insert
• Limited Lifetime Warranty

Made of injection-molded ultra-high-strength polypropylene copolymer resin, this SKB iSeries 1309 Waterproof Case is made to protect your delicate gear from the most extreme and demanding shipping, handling, and working conditions on the planet. The case is offered here with a custom-cut foam insert that is specifically made to hold a Sony A7R IV, A7 III, A7R III, or A7 series camera body with a lens attached, lens hoods, two additional lenses plus accessories. A removable section of foam will accomodate even a long 70-200mm lens attached to your camera, and each of the two additional lens slots has three removable concentric rings to accommodate a variety of lenses. Convoluted eggcrate foam in the lid and a solid foam base layer complete the protection for your equipment.

Case design features include gasket sealing to an IP67-rating that makes it dust and waterproof, a molded-in hinge for added protection, dual stainless steel reinforced padlock holes, and a trigger release latch system. Polypropylene resin is is not only strong, it is also resistant to a variety of hazards that you may encounter such as impacts, ultraviolet (UV) radiation, solvents, corrosion, and even fungi. A pressure relief valve comes into play especially during air transport by regulating the internal pressure, keeping your gear and the case from getting crushed and allowing you to open the case without having to break a tough pressurized seal that may develop.